Raindance Showerpanel27005XX1Installation Instructions / Warranty
10Justify the Thermostatic Mixer HandleSet the High Temperature Limit Stop (optional)Turn the water on to the handshower.Turn the thermostatic mixer h
11Turn the water on to the handshower. Turn the temperature control stem until the output water is the desired maximum high temperature -- usually 11
12Using the DiverterPull the lever upward to turn the water on. Pivot the handle to the desired function. There are five functions:Alll-around shower
13Scale RemovalThe Raindance Air 3-jet handshower incorporates the RubitTM cleaning system. If scale deposits are noticed in the spray channels, turn
14Rinse the handshower with clear water. Reinstall the handshower. Turn on the water and allow the handshower to flush for at least one minute.
15TroubleshootingProblem Possible Cause RemedyInsufficient water - Supply pressure inadequate - Filters on thermostat cartridge dirty- Screen washer
1612345681011121314151618202223x225x229x2,51779192166
171 handshower 28519XXX2 slider 97024XXX3 handshower hose, 63” 28276XXX4 upper cover 973240005 escutcheon 973260006 body shower
18Limited Lifetime Consumer WarrantyThis product has been manufactured and tested to the highest quality standards by Hansgrohe, Inc. (“Hansgrohe”).
19including, without limitation, a commercial purpose, this warranty extends only (i) for 1 year, with respect to Hansgrohe and Commercial products, a
2Raindance Showerpanel27005XX1
Hansgrohe, Inc. • 1490 Bluegrass Lakes Parkway • Alpharetta, GA 30004Tel. 770 360-9880 • Fax 770 360 9887www.hansgrohe-USA.comUS - Installation Instr
3Technical DataOperating pressure: max.145 psiRecommended pressure: 30 - 60 psiTest pressure: 232 psiMax. hot water temp.: 176° F*Recommended h
4Preparation for InstallationInstall 1/2” IPS nipples for the hot and cold water supplies at the locations shown on the diagram. The nipples should e
5InstallationWrap the nipples with several layers of Teflon tape.Install the elbows included with the panel. The outlets should point downwards. The
6Drill the screw holes with a 6 mm bit suitable for the wall surface.Install the anchors. Seal the wall around the anchors with water-proof sealant.
7Install the center and bottom screws and washers. Connect the supply hoses to the hot and cold supply elbows.Connect the supply hoses to the hot and
8Once you ensure that the connections are water-tight, push the diverter stem down to turn the water off to the panel. Install the side seals on the
9Install the diverter handle. Tighten the set screw with a 4 mm Allen wrench.Place a black rubber washer in one end of the handshower hose. Screw th
Commentaires sur ces manuels